Code: 64510350

Additional Images



Not compatible with Foxtel iQ2/iQ3

The HDMIFIB is a long-range HDMI video extender kit that uses SC fibre-optic cable to extend video, audio, Ethernet and IR from an HDMI-equipped device to a remote display up to 20km away! The extender supports full High-Definition video (1920×1200 / 1080p) and includes both the transmitter and receiver, for a simple digital signage solution.

Not only is this an incredibly long range solution that can extend an HDMI signal across or between buildings, but because fibre optics transmit data using light rather than electrical signals, it be affected by or cause electromagnetic interference (EMI).

For convenient, cost-effective control of the media source, the HDMI extender also offers Infrared (IR) extension, which enables you to control the HDMI audio-video source from either end of the connection. Finally, the connection of Smart TVs and other remote data hungry devices is made simple with Ethernet pass-through maintaining a high quality data connection better than straight CAT6 runs.


  • Extends 1080p HDMI signals up to 20km over a fibre optic cable
  • Provides high-resolution image quality
  • Plug-and-play operation—no programming or setup required
  • Ethernet pass-through
  • Optical fibre rules out any RF interference


Operating Temperature -5 to +35°C
Storage Temperature -10°C~70°C
Operating Humidity 10 to 90%RH (No Condensation)
Storage Humidity 5 to 90%RH (No Condensation)
Fibre Module 1310nm single mode
Fibre Connector SC Duplex Connector
Transmission Distance 1080P 36bit @60Hz 20km (Maximum)
Ethernet 100Mbit
Power consumption Tx: 8W Max
Rx: 8W Max
IR wavelength &frequency Wavelength:940nm, frequency 38kHz
Dimension L×W×H) Tx: L154 x W99.5 x H27 mm
Rx: L154 x W99.5 x H27 mm
Net Weight Tx: 410g
Rx: 410g
LED Indicators Power, Link/Act, Speed

Note: Specifications are subject to change without notice. Mass and dimensions are approximate.


  • Power input port
  • Reset button
  • IR port
  • HDMI input
  • Duplex SC port
  • Power, Link/Act and Speed Indicator LEDs
  • Ethernet port

{tab=In the box}

  • Main Unit. Transmitter & Receiver HDMI Extender
  • 2x Power adapters DC 5V/2A
  • IR Emitter
  • IR Receiver
  • Operating Instructions

{tab=Connection Diagram}
Simple diagram


Quick start guide

Print Page Share This Find a Dealer